30 Day's Mechanical Design Engineers Guide Series

Day 1 - Introduction to Mechanical Design Engineering — Day 1 – Introduction to Mechanical Design Engineering

Day 2 - Engineering Drawing Fundamentals — Day 2 – Engineering Drawing Fundamentals

Day 3 - Basics of CAD Modeling — Day 3 – Basics of CAD Modeling

Day 4 - Part Modeling in CAD — Day 4 – Part Modeling in CAD

Day 5 - Assembly Modeling — Day 5 – Assembly Modeling

Day 6 - Drafting & Detailing — Day 6 – Drafting & Detailing

Day 7 - GD&T Fundamentals — Day 7 – GD&T Fundamentals

Day 8 - Advanced GD&T — Day 8 – Advanced GD&T

Day 9 - Engineering Materials — Day 9 – Engineering Materials

Day 10 - Manufacturing Processes — Day 10 – Manufacturing Processes

Day 11 - Design for Manufacturing (DFM) — Day 11 – Design for Manufacturing (DFM)

Day 12 - Design for Assembly (DFA) — Day 12 – Design for Assembly (DFA)

GD&T Reference Update:

The original GD&T infographic published in this article contained a few symbol inaccuracies generated during the AI image creation process.

To ensure technical accuracy and compliance with ASME Y14.5-2018, the chart has now been updated with verified GD&T symbols based on standard engineering references.

Key Corrections:
• Symmetry symbol corrected.
• Circular Runout symbol corrected.
• Total Runout symbol corrected.
• All GD&T symbols reviewed against ASME Y14.5-2018 reference standards.

This updated chart should be used as the reference image for learning GD&T fundamentals.

Note: Concentricity and Symmetry are shown for educational purposes only and are identified as deprecated controls in ASME Y14.5-2018.

— CAD DESIGNS
www.caddesigns.in